AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Trex rainescape trough12/8/2023 Thus, we cannot warranty our product when lesser quality supplies are used. Other tapes and caulks may not work well. Do NOT use any products that Trex RainEscape does not manufacture.While rainwater or a hose often does a sufficient job of keeping the gutters clear, there are times, such as in the case of a heavy leaf fall or an unusual amount of debris accumulation, that you may need to clean out with the access panel. The panel allows you to check the gutter without removing the soffit. For more installation tips, view this video. Choose one of these two methods: fold a soft crease lengthwise down the center of the trough to relax the material or unroll it and let it sit for a while to get used to the temperature. If you’re in a climate with fluctuating temperatures, you’ll want to take this step, especially important when installing the black trough. Cover all joists and blocking with trough material, then tape with Trex RainEscape butyl tape. Add outlets to the gutter every 12′ – 14′. Follow all installation recommendations. It’s much easier when one of your duos holds the trough taut and the other staples it into place. The Trex RainEscape under-deck drainage system is more easily installed when one person can hold the trough, so it doesn’t roll up while another installs it. This list of do’s and don’ts will make your life easier and your customers happier. With these 12 pro tips, you can enjoy a more successful Trex RainEscape installation. When it comes to any construction project, you can do it the hard way or the best way. Q: If I have a question, how do I get additional information?Ī: For additional questions, please call a Trex RainEscape Specialist at 1-87 or email. Q: How do I clean the Trex RainEscape Soffit light?Ī: No special cleaning instructions are required for the Trex RainEscape Soffit light. How bright is the Trex RainEscape Soffit light?Ī: The output of the Trex RainEscape Soffit light is about 445 lm which is roughly equivalent to a 45W floodlight in the same color temperature. Visit our Warranty page for full details. Does Trex RainEscape come with a warranty?Ī: Yes, Trex RainEscape is warranted to last for 20 years from the date of purchase. Care should be used in choosing fasteners so as not to cause issues with the RainEscape system. The low-E glass reflects more sunlight, and it can be observed that the extra reflectivity combined with any concavity in the glass can act as a concave mirror, concentrating sunlight onto outdoor objects including decking. This can result in an extreme amount of heat in areas of the decking surface which can cause more movement of the deck than usual. Can I install the Trex RainEscape system near Low-E Doors and Windows?Ī. Yes, but caution must be used. Do not try to repair any damage with the Trex RainEscape tape. See our instructions for spans that are longer than the trough material. In areas, such as the perimeter, or surfaces of brick or stucco where the Trex RainEscape tape will not stick, use the Trex RainEscape caulking to adhere the material.Ī. Q: What if I can’t get the tape to stick?Ī. If leaves and debris accumulate in the troughs, a standard washing or hard rain will clean out the system. With no water remaining in the system, freezing is not an issue.Ī: Snow will sit on the decking and, as it melts, will run through the system.Ī. Q: Is the Trex RainEscape System affected by freezing temperatures?Ī: If the system is installed correctly any water that is caught drains out through the downspout in a matter of seconds. In this case, simply flush out the system with water as needed or at least once a year. If your deck is in a leafy area, there may be some build-up. Small debris simply passes through the system with water. This will protect the Trex RainEscape system from sun, snow, and rain. Trex RainEscape is backed by a 25-year warranty.Ī: In most cases, there is a very little amount of debris that enters the RainEscape gutter system because it has to be small enough to fit through the decking. Q: Can I use Trex Protect tape when installing the Trex RainEscape system?Ī: No, Trex Protect is used to protect the joists and beams of a deck foundation and cannot be used to install the Trex RainEscape system.Ī: Trex RainEscape is made with durable poly and ultraviolet inhibitors. The existing deck boards must be removed before you install the Trex RainEscape System. Q: Can I install this over an existing deck?Ī: Yes, but it is not ideal. For more information, visit our Installation page and view our detailed installation videos on our YouTube channel. Most systems can be installed in one or two hours. The materials required for installation are scissors or a utility knife, a staple gun, and a caulking gun. Detailed installation instructions come with the Trex® RainEscape® system. Q: Can I install the RainEscape system myself?Ī: Yes, but it is easier to install with two people.
0 Comments
Read More
Leave a Reply. |